AQUA Graphene Coating

Przygotowanie powierzchni

For both new and used vehicles it is recommended machine paint correction, adjusted to its state of wear. The final stage of preparation should be thorough degreasing the surface with isopropyl alcohol.

Before application, the varnish must be:

• perfectly clean,

• dry,

• free from tar residues, metal filings and impurities.

Aplikacja

1. Open the product and apply a few drops of coating on unused AQUA suede microfiber.
   If you are not familiar with this product, application is recommended with just the applicator, without the suede cloth– this makes it easier to work in more difficult conditions.

2. Select a vehicle element, e.g. the hood, and start the application using the cross – horizontal and vertical movements.
   Large components, such as the hood or roof, may need to be divided into several sections.

3. The product layer during application should be wet and even.Do not apply the product too thinly.

4. Then spread the coating again in the same place using the applicator alone, without adding another portion of the product.

5. Wait about 15-30 seconds, depending on temperature and operating conditions.
   If you work slower or the temperature is higher, do not delay in breaking in and remove excess product immediately after application.

6. Remove excess coating using the first pure AQUA microfiber.
   The first movements should be quick and long.

7. Then use second microfiber, making gentle circular movements to thoroughly reach the surface.

8. For full control of the finish it is recommended to use third microfiber and an inspection flashlight to remove any streaks without pressure.

9. Polish the paintwork until it is completely clear, shiny and streak-free.

Po aplikacji

After completing the application on all vehicle components, it is recommended to leave the car in stable conditions for 24 godziny.

If the car has to leave the studio early and will be exposed to moisture or unfavorable weather conditions, it is recommended to apply Coating Booster.

Within the first 2 weeks The coating is fully cured. During this time, avoid excessive dirt on the vehicle. However, if the car does become dirty, washing it safely with a gentle, neutral detergent is a better option than leaving the dirt on the surface.

At a minimum 10 hours after application it is recommended to apply Coating Booster, which additionally supports the fresh coating, limits contact with dirt and improves resistance to external conditions.